SDMO RES 9.5 EC Manuel D'installation page 113

Parameter
Generating set nominal
voltage and frequencies
Generating set
configuration
Type of engine
Type of engine data
input
Battery voltage:
Communication setting
Parameter
Generating set nominal
voltage and frequencies
Type of engine
Communication setting *
* Controller application code version 1.13 or higher
** Default setting for application code version 1.13 or higher
Figure 2.35: Controller configuration settings, RES 18 EC / RES 12 TEC / RES 16 TEC
Note: Ensure that the selections made have been saved before exiting configuration mode. The controller restores the selections
most recently saved when the main switch is set to "OFF/RESET".
Code
Uu01
Uu06
Uc01
Ec00
Ed05
Bt12
Cn00
Figure 2.34: Controller configuration settings, RES 9.5 EC / RES 13 EC
Code
Uu01
Uu03
Uu06
Ec00
Ec12
Cn00
Cn01**
Description
Single phase, 60 Hz, 120/240 VAC
Single phase, 50 Hz, 115/230 VAC
RES 9.5 EC / RES 13 EC (backup)
RES 9.5 EC / RES 13 EC
Low coolant level digital value, pressure
digital value, temperature analogue value,
with magnetic sensor
Engine starter battery voltage, 12 VDC
Without CAN communications
Description
Single phase, 60 Hz, 120/240 VAC
Three-phase, 50 Hz, 230/400 VAC (TEC)
Single phase, 50 Hz, 115/230 VAC
RES 12 TEC
RES 18 EC / RES 16 TEC
No J1939 communication.
Sleep mode enabled (48-hour power
down in AUTO)
J1939 communication enabled.
Sleep mode disabled (no power down in
AUTO)
37/73