Errors And Remedies - Salvis Master VisionPRO Mode D'emploi

en
7.

Errors and remedies

Check any faults in the appliance against the following table:
Fault
The green indicator
light or the ring does
not light up when the
appliance is switched
on.
The appliance is
switched on but does
not heat up.
The appliance is not
heating up and the in­
dicator light or the
scale ring is not lit.
The pump is switched
on, but does not
provide cooking oil/fat.
The pump does not
provide cooking oil/fat
even after running for
three minutes.
If you cannot remedy the fault,
− turn off the appliance and disconnect from the mains;
− do not open housing but
− contact Customer Service.
46 / 96
Possible cause
Main switch before appliance
not turned on.
There is no power supply at all.
Mains fuse has tripped.
An energy optimization unit be­
fore the appliance is not switch­
ing on the heating.
Safety temperature limiter has
tripped.
There is insufficient cooking oil
or cooking fat in the container.
The pump sucks in air.
Solid cooking fat was used. The
cooking fat has solidified in the
container.
The O-ring (round ring) on the
connector piece of the intake
tube is defective or has failed.
The pump sucks in air.
Pump vanes worn.
Remedy
Turn on main switch.
Inform electricity
company.
Have possible appliance faults checked
by an authorised Customer Service agent.
Reset mains fuse.
Check the energy optimization unit.
Allow the appliance to cool.
WARNING! Fire danger! Do not switch the
safety temperature limiter back on until
the cause of the failure has been rectified.
Have Customer Service switch on the
safety temperature limiter and have the
appliance checked.
Fill the tank or container with cooking oil
or semi-liquid cooking fat.
Scoop the solidified cooking oil from the
container. Use cooking oil or semi-liquid
cooking fat!
Install a new O-ring (round ring).
contact Customer Service.