Stryker XPRT 2950 Manuel D'utilisation page 46

English
1 .
D-Ring on
Footbox
4 .
Return To Table of Contents
1-42
Product Labels
P/N 101385000 Rev A 06/10
Not to be removed until
delivered to the consumer
Ne pas enlever avant la
livraison au consommateur
This article contains
NEW MATERIAL
ONLY
Cet article contient des
MATÉRIAUX NEUFS
SEULEMENT
This label is a xed in compliance
withP rovincial Law
Cette étiquette est apposée
conformément à la loi de la province
Made by
Fabriqué par
reg.No.
No. De permis
1680-278
36762
05T-00238410
Content
Contenu
48%
METAL
METAL
34%
URETHANE FOAM
MOUSSED'URETHA
12%
GEL
GEL
6%
URETHANE FILM
FILMD'URETHANE
XPRT MATTRESS INSTALLATION INSTRUCTIONS
Push pendant onto retainer pin on either side of footbox.
Plug power cord into footbox.
CAUTION: Do not plug into power source until assembly is
complete.
Snap retainer strap over power cord.
Mattress
Tie Down
Retaining
Strap Clip
5. Lower the foot section of mattress over
footbox. Attach the mattress to the bed
frame using the mattress tie-downs.
Fasten 2 Retaining Strap Clips to 2
D-Rings on foot box.
THIS TAG NOT TO BE REMOVED
METAL.................................... 48%
URETHANE FOAM.............. 34%
GEL.......................................... 12%
URETHANE FILM................. 6%
Certi cation is made by the manufacturer
Finished Size:
35"W x 84"L x 8 1/2"H
3 . Connect the 3 color coded connectors on the footbox to
2 . Place mattress on bed litter, with printed
the corresponding color coded connectors on the
logo at head end of bed.
mattress.
Fold back foot end section of mattress.
Turn the locking collars clockwise to secure the
Place footbox with pendant on foot end of
connections.
bed litter.
Connect the air line from the mattress to the
corresponding tting on the footbox.
D-Ring
(b)
6. Apply linens, utilizing D-Rings for at sheet.
To secure linens (a) to Mattress (b), thread
four corners through D-Rings (c), attached
to mattress as shown in drawing. To ensure
proper therapy, do not pull linens taut.
Linens should remain loose and wrinkly on
surface of mattress.
2950-109-005 REV B
P/N 101386000 RevA 06/10
UNDER PENALTY OF LAW
EXCEPT BY THE CONSUMER
ALL NEW MATERIAL
consisting of
REG. NO. CA34324(NY)
that the materials in this article are
described in accordance with law.
Manufactured By:
Gaymar Industries, Inc.
10 Centre Drive
Orchard Park, NY 14127 USA
1.716.662.2551
TYM3584 Pulmonary Mattress
Manufactured in:
Month Year
NetWt.
70lb.
Made In USA
THIS PRODUCT MEETS THE
REQUIREMENTS OF THE CALIFORNIA
BUREAU OF HOME FURNISHINGS
TECHNICAL BULLETIN 603.
(a)
(c)
7 . Plug the power cord into power
source.
P/N 13051000 5/06
www.stryker.com