Stryker XPRT 2950 Manuel D'utilisation page 56

English
INSTALLATION OF NEW CELL ASSEMBLY (CONTINUED)
3 . Fold back cell assembly to expose tubing .
4 . Insert tubing into opening in foam crib .
Note: Maintain tubing orientation .
5 . Fold back head end of support
surface . Refer to Figure 3 .
Note: Two people required to fold back foam crib and
head box .
6 . Connect tubing to new 90 degree fittings, two
places . Rubbing (Isopropyl) alcohol may be applied
to fittings for easier installation . Ensure fittings are
fully inserted into tubing . Refer to Figure 10 .
7 . Return head end of support surface down to original
flat position .
Note: Two people required to fold back foam crib and
head box .
Return To Table of Contents
1-52
Service Information
2950-109-005 REV B
Figure 8
Figure 9
Figure 10
www.stryker.com