Publicité
8. Large Chopping/Mixing Blade
9. Fine Slicing & Fine Grating/Shredding Disc
10. Medium Slicing & Medium Grating/ Shredding Disc
11. Housing Base
12. Control buttons
4. USE
BEFORE FIRST USE
Take care when unpacking the chopping/mixing blades and the reversible slicing/grating discs.
The blades are very sharp and could cause injury.
To avoid injury, ensure the raised fi nger grips on the plastic casing are used to remove the blades
from their plastic packaging and carefully remove cardboard and tape from the reversible slicing/
grating discs. Retain the plastic casings for safe storage.
Before using your Cuisinart Easy Prep Pro for the fi rst time, wash the large and small work bowls,
work bowl cover, pusher accessory, chopping/mixing blades, and both slicing/grating discs.
A. SELECTING THE WORK BOWL
• The Food Processor is supplied with two work bowls.
• The large work bowl has a maximum capacity of 1.9L and can be used with the large chopping/
mixing blade and the two reversible slicing and grating/shredding discs.
• The small work bowl has a maximum capacity of 0.7L and can be used with the small chopping/
mixing blade only. The seal on the inner bowl prevents any leakage into the large work bowl,
allowing you to use the small bowl without the need to wash up the large bowl after use.
N.B. The large work bowl must always be fi tted before the small work bowl can be set up inside.
It will not always be possible to use the work bowls to their maximum capacity. The amount of
food/liquid you can process in the bowls will depend on the density of the ingredients in the
work bowl and the consistency of the desired end result. For example, to achieve a consistent
result when chopping or pureeing nuts, fruits, vegetables or meats you may need to process in
batches of 300-500g. If you are mixing dough which can be very dense, you may need to process
in batched of around 400g.
If you fi nd that the motor is struggling or that the processing results are uneven, then we would
recommend that you reduce the amount of ingredients in the work bowl and instead process in
batches.
For liquid, we recommend that you do not fi ll the bowls above the Maximum Liquid Fill markings
on each bowl (700 ml on the large work bowl and 300ml on the small work bowl.) This is to avoid
liquid spilling into the central spindle which may cause leakage.
N.B. If you are processing very thin liquid such as water in the large bowl, you may need to reduce
the amount of liquid to around 600ml to avoid thin liquid escaping from the lid.
B. SELECTING THE BLADE/DISC
For chopping, mixing, blending and puréeing use the chopping/mixing blades.
• The large chopping/mixing blade can only be used with the large work bowl.
• The small chopping/mixing blade can only be used with the small work bowl.
21
Publicité
