Publicité
21.
CNC 8058
CNC 8060
CNC 8065
R
: 2102
EF
ꞏ424ꞏ
Exemple de sous-routine G501. Activer le HSC sous le mode FAST.
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
; HSC ROUGHING ACTIVATION
; E - Contour Tolerance
; A - % Acceleration
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
#ESBLK
#HSC OFF
#PATHND ON
$IF V.C.PCALLP_A
G131 P0
$ELSE
G131 100
$ENDIF
$IF V.C.PCALLP_E == 0
P4 = 2 * V.MPG.HSCROUND
$ENDIF
#HSC ON [FAST, EP4]
V.G.DYNOVR = 120
#RETDSBLK
Exemple de sous-routine G502. Activer le HSC sous le mode SURFACE.
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
; HSC FINISHING ACTIVATION
; E - Contour Tolerance
; A - % Acceleration
;-------------------------------------------------------------------------
;-------------------------------------------------------------------------
#ESBLK
#HSC OFF
V.G.DYNOVR = 100
#PATHND ON
$IF V.C.PCALLP_E == 0
P4 = V.MPG.HSCROUND
$ENDIF
$IF V.C.PCALLP_A
G131 P0
$ELSE
G131 100
$ENDIF
#HSC ON [SURFACE, EP4]
#RETDSBLK
M a nu el d e p rog r amm a t io n.
Publicité
