Meters - HONDA marine BF40D Instructions D'utilisation

METERS

Meter Installation
Meters and other instruments should be installed on
the instrument/mounting panel. If any other location
is selected, it will be necessary to use a mounting
plate with a thickness of 2 – 11 mm (1/16 – 7/16 in).
• If mounting plate thickness exceeds 11 mm (0.4
in), the mounting bracket must be modified
accordingly.
• Tighten the mounting nuts evenly on both sides.
• Meter installation angle should be within 45° - 75°.
• If the boat has a magnetic compass, install the
tachometer at least 130 mm (5 in) away from the
compass.
Installation hole diameter:
Tachometer 80.5 mm (3.17 in)
Trim meter 52.5 mm (2.07 in)
Voltmeter 54.0 mm (2.13 in)
Hour Meter 50.4 mm (1.98 in)
MOUNTING PANEL
THICKNESS: 2 – 11 mm (0.04 – 0.44 in)
RECOMMENDED INSTALLATION
ANGLE: 45° – 75°
MOUNTING NUT
Speedometer Tube Installation
1) Cut off the sensor nipple end at 3 mm (0.12 in)
2) Pass the tube through the swivel bracket as
3) Connect it to the nipple end and secure with the
MOUNTING BRACKET
• Attach the tube to the hull securely. Take care not
• If the sensor tube is clogged with salt or any other
• Drain the tube before prolonged storage of the
• Before securing the tube on the hull, steer the
43
from the end.
NIPPLE END
APPROX.
3 mm (0.12 in)
shown.
wire harness band.
SENSOR TUBE
to bend or pinch the tube.
foreign material, remove it from the sensor tube
using a wire or equivalent tool.
outboard motor.
outboard motor fully to the right and left and tilt it up
and down fully to check whether the tube is not
pulled or pinched.
WIRE HARNESS
BAND
TUBE