HONDA marine BF40D Instructions D'utilisation page 24

SHIFT CONTROL CABLE
1) Set the control lever to the "N" (Neutral) position
and check that the shift link B is in the "N"
position.
"N"
CLICK ROLLER
2) Set the shift lever in the "N" (Neutral) position and
move it a couple of times back and forth within
the range of free play.
FREE PLAY
SHIFT LEVER
3) Move the gear shift lever to the "F" (Forward)
position and return it to the "N" (Neutral) position
slowly. While holding the shift control cable and
the gear shift lever in this position, mark A at the
end of the cable outer seal on the inner cable.
MARK A
OUTER CABLE SEAL
4) Move the gear shift lever to the "R" (Reverse)
position and return it slowly to the "N" (Neutral)
position. While holding the gear shift lever in this
position, mark B at the end of the cable outer seal
on the inner cable.
MARK B
5) Mark C at the midpoint between the mark A and
6) Align the mark C made with the end of the cable
SHIFT LINK B
"N"
7) Connect the shift control cable to the shift arm
8) After connecting the shift control cable, make
OUTER CABLE SEAL
22
the mark B on the inner cable.
MARK C
MARK A
outer seal. Adjust the shift control cable length so
that the pivot shift on the shift control cable can
be set on the shift arm smoothly. After
adjustment, tighten the lock nut securely.
MARK C
OUTER CABLE SEAL
and secure with the 6 mm washers and 6 mm
lock pin.
• Set the washers on both sides of each arm as
shown.
6 mm LOCK PIN
SHIFT ARM
SHIFT PIVOT
LOCK NUT
6 mm WASHER (2)
SHIFT ARM
SHIFT CONTROL CABLE
sure that the shift lever moves smoothly and the
shift mechanism operates properly.
Adjust the shift control cable (see page 41), if
necessary.
MARK B
6 mm WASHERS
SHIFT CONTROL
CABLE
6 mm LOCK PIN