Control Box Installation; Control Lever Friction Adjustment - HONDA marine BF40D Instructions D'utilisation

CONTROL BOX INSTALLATION

Set a spacer between the remote control box and the
boat to obtain the clearance for operation of the
control lever.
Connect the control cable to the remote control box
before installing the remote control box.
1) Select the remote control box installation position
(see page 26)
2) Mark the drilling points for the remote control box
mounting screws.
3) Drill at the marked points using the 7 mm
diameter drill bit.
4) Connect the control cables to the remote control
box (see page. 31).
5) Install the remote control box using the collars
washers, nuts and the screws.
• Set the spacer and washers between the
remote control box and the mounting surface on
the boat as shown to obtain the clearance for
smooth operation of the control lever.
• Install the remote control box with the control
lever set in the neutral position.
CONTROL BOX
CONTROL
LEVER
SPACER
COLLAR
6 mm SCREW
WASHERS
CONTROL LEVER FRICTION
ADJUSTMENT
Adjust the friction by turning the control lever friction
adjuster.
CONTROL LEVER
FRICTION ADJUSTER
NUT
38
To increase
friction
To
decrease
friction