Installation - HONDA marine BF40D Instructions D'utilisation

Boat Transom Height Adjustment
• If the outboard motor installation height is too low,
attach wood block(s) to the top of the transom and
increase the installation height by the amount it is
required.
• If the outboard motor installation height is too high,
reduce the height by planing down the top of the
transom by the required amount.
• When increasing the installation height, attach the
wood block(s) to the transom of the boat securely.
• Be sure to plane off the boat transom by the
amount of the outboard motor width.
• Some boat manufacturers may require different
mounting height. Consult your boat manufacturer
for specifics on your boat.
OUTBOARD MOTOR WIDTH
Cut away

INSTALLATION

Drilling the Mount Bolt Holes
1) Mark two installation hole points (four in total) on
the transom of the boat at the right and left mirror
image positions with the transom center line in
between.
• Do not drill a hole in the wood block attached to
the transom of the boat.
• Be sure that the upper bolt holes are not
located above the position shown in the
drawing (more than 25 mm /1.0 in) from top of
the transom board).
• Drill the lower bolt holes so that mounting bolts
contact the upper end of the stern bracket.
φ12.2 (0.48)
327 (12.9)
250.8
(9.87)
2) Drill the pilot holes using a 3 - 5 mm drill bit.
• Drill at right angles to the transom board.
3) Drill the bolt holes precisely at the marked points
with the 12.2 mm (0.53 in) drill bit.
φ3 - 5 mm DRILL BIT
90°
15
Unit：mm (in)
TRANSOM
BOARD TOP
φ12.2 mm DRILL BIT
90°