HONDA marine BF40D Instructions D'utilisation page 22

1) Install the lock nut and shift pivot on each control
cable.
• Set each shift pivot at the position 5 mm (0.2 in)
or more from the cable end as shown.
• Apply the marine grease to the pivot pins.
CONTROL CABLE
LOCK NUT
(Marine grease)
5 mm (0.2 in) OR MORE
2) Pass the starter cable and handle cable through
the under case grommet A, and install them in the
outboard motor.
3) Set the harness band clip on the clip bracket and
clamp the handle cable with the harness band
clip.
4) Connect the connectors to the main wire harness
and set them on the holders.
HOLDERS
HANDLE CABLE
HARNESS BAND CLIP
UNDER CASE
GROMMET A
SHIFT CONTROL CABLE
THROTTLE CONTROL CABLE
HANDLE CABLE
STARTER CABLE
Viewed from out side
5) Install the control cable set plate in the groove of
6) Pass the throttle and shift control cables through
THROTTLE CONTROL
CABLE
SHIFT PIVOT
CONTROL CABLE
SET PLATE
7) Install the separator cover with the 6 x 28 mm
6 x 28 mm FLANGE BOLT (2)
MAIN WIRE HARNESS
STARTER
CABLE
6 mm WASHER (2)
20
the under case.
the under case grommet A, and set them on the
control cable set plate by aligning the groove with
the cutouts in the control cable set plate.
SHIFT CONTROL CABLE
UNDER CASE GROMMET A
flange bolts, 6 x 40 mm hex. bolts and 6 mm
washers.
SEPARATOR COVER
6 x 40 mm HEX. BOLT (2)