Language, time, display
Offset
Button lock
C
End user level menu structure (expanded and additional functions with control
module)
C.1
Menu item: Control
MENU
CONTROL
Zone:
Heating
Mode:
Off
Time-contr.
Weekly planner
Set-back temperature:
Manual
Cooling
Mode:
Off
Time-contr.
Weekly planner
Manual
Zone: 1
Absence
198
Language:
Date:, After the power is switched off, the date is retained for ap-
prox. 30 minutes.
Time:, After the power is switched off, the time is retained for ap-
prox. 30 minutes.
Display brightness:, Brightness during active use.
Daylight saving time:, On, Off
Offset setting. Comparison of the temperature difference between
the measured value in the system control and the value for a refer-
ence thermometer in the living room.
Yes, No
Blocks the keyboard.
To unblock, press and hold
Heating is switched off, domestic hot water continues to be avail-
able, frost protection is activated
Set the time periods.
Up to 12 time periods and desired temperatures can be set per
day.
Desired temperature:: Applies within the time periods
ENTER START TIME
ENTER END TIME
Add time periods
Copy settings to...
Delete all time periods
The set-back temperature applies outside of the time periods.
Desired temperature:: °C
Cooling is switched off, domestic hot water remains available
Set the time periods.
Up to 12 time periods can be set per day; cooling is switched off
outside of the time periods.
ENTER START TIME
ENTER END TIME
Add time periods
Copy settings to...
Delete all time periods
Uninterrupted retention of the desired temperature
Desired temperature:: °C
Changing the name Zone , which was set at the factory
Applies for the selected zone in the specified time period
During this time, heating mode runs at the defined set-back tem-
perature. Domestic hot water mode and circulation are switched
off. Frost protection is activated; existing ventilation runs at the
lowest level.
Factory setting: Set-back temperature 15 °C
Away from
Away until:
Operating instructions 8000017440_FT
for at least four seconds.