Publicité
B
24 °C
21 °C
1
16 °C
5
16:30
18:00
A
Time
B
Temperature
1
Time period 1
2
Time period 2
Time periods are already set for each day of the week at
the factory.
You can divide a day up into several time periods (3) and
(5). Each time period can comprise an individual start time
and end time. The time periods must not overlap. You can
assign a different desired temperature (1) to each time
period.
Example:
16:30 to 18:00; 21 °C
20:00 to 22:30; 24 °C
The living rooms are regulated to the desired temperature
within the time periods. In the times outside of the time peri-
ods (4), the living rooms are regulated to the lower set-back
temperature (2) that is set.
For domestic hot water mode and domestic hot water mode
with circulation, you can save up to three time periods with
a set domestic hot water temperature for each day of the
week. Domestic hot water mode is deactivated outside of
the time period.
For heating mode, you can save up to 12 time periods for
each day of the week. You can set an individual desired
temperature for each time period. The set desired temper-
ature applies within these time periods. The set-back tem-
perature applies outside of these time periods.
0
192
3
2
4
5
5
22:30
20:00
3
Desired temperature
4
Set-back temperature
5
Outside of the time
periods
3
6
9
12
15
18
21
24
The active list entry is displayed lit up in white.
You can use Copy settings to... to transfer start and end
time periods that have already been programmed to an-
other day of the week.
You can find simplified programming of the time periods
for heating mode under MENU | CONTROL | Time pro-
gramme assistant.
4.5
Setting time periods using the time
programme assistant
Validity: Product with control module
A
You can use a time programme assistant for heating mode.
The time programme assistant guides you through the
planning. There is a block for Mon–Fri and Sat–Sun.
The time programme assistant overwrites the weekly plan-
ner that has been created for heating mode.
4.6
Heating mode
In heating mode, the rooms are heated up in accordance
with your settings.
4.6.1
Setting the flow temperature/desired
temperature
Condition: No system control connected
▶
From the basic display, press
◁
The flow temperature/desired temperature that has
already been set is shown on the display.
▶
Set the desired flow temperature/desired temperature.
Condition: System control connected
▶
Set the flow temperature/desired temperature on the
system control, → System control operating instructions.
4.6.2
Setting the desired temperature as time-
controlled
Validity: Product with control module
1.
Call up MENU | CONTROL | Zone: | Heating |
Mode:.
2.
Activate the Time-contr. mode.
3.
Call up the Weekly planner and program the re-
quired time periods and the desired temperature for
each day of the week.
4.
Call up MENU | CONTROL | Zone: | Heating |
Mode: | Time-contr. | Set-back temperature:.
5.
Set the required set-back temperature.
4.6.3
Setting the time-limited desired temperature
Validity: Product with control module
1.
From the basic display, press
◁
The desired temperature that has already been
set is shown in the display.
2.
Set the desired temperature.
3.
Set the required time period.
.
.
Operating instructions 8000017440_FT
Publicité
