Publicité
E.3
Menu item: Installation assistant
MENU | SETTINGS | Installer level
Installation assistant
Language:
Enter code
Set the current date.
Set the current time.
ODU missing. Start comfort protect.?
Has a control been installed?
Fill the building circuit with water.
Building circuit purge programme
Immersion heater output limit
Set the cooling technology.
Installer contact info
E.4
Menu item: QR service code
MENU | SETTINGS | Installer level
QR SERVICE CODE
E.5
Menu item: Competent person's contact details
MENU | SETTINGS | Installer level
Installer contact info
E.6
Menu item: Service date
MENU | SETTINGS | Installer level
Service date:
E.7
Menu item: Test programmes
MENU | SETTINGS | Installer level
Test modes
Check programmes
P.04 Heat. mode with compressor
P.06 Purge programme
P.11 Cooling technology
P.12 Thawing
P.27 Heat. mode with imm. heater
P.30 Filling programme
Actuator test
T.01 Building circuit pump
T.02 3-port valve for domestic hot water
T.17 Fan 1
T.21 EEV position
T.19 Condensate tray heater
T.119 Multi-function output 1
T.126 Multi-function output 2
8000017440_FT Installation and maintenance instructions
Selecting the language
Factory setting: 00, access code: 17
Yes
No
Yes
No
Starting the programme
Starting the programme
0.5; 1; 1.5; 2; 2.5; 3; 3.5; 4; 4.5; 5; 5.5; external back-up heater
No cooling
Active cooling
Do not enter any contact details
Enter installer contact details
This is where you can use the Service App's QR code scanner to
read important unit data.
Enter the contact details for the competent person mode: Phone
number, company name
Enter the next service date for a connected component, e.g. heat
generator
Setting: Compressor target flow temperature in °C
Select
Setting: Target flow temperature
After being selected, the de-icing starts immediately and cannot be
cancelled.
Target flow temperature setting 25–50 °C
Select
1–100%, increment 1
Heating, Midd., DHW
1–100%, increment 1, factory setting: 0
1–100%, increment 1, factory setting: 0
On, Off
For the automatic selection ON, factory setting: OFF
For the automatic selection ON, factory setting: OFF
247
Publicité
