Publicité
Note
The domestic hot water temperature is only dis-
played if no system control is connected.
The flow temperature is the temperature at which the heating
water leaves the heat generator (e.g. 65 °C).
The desired temperature is the temperature that is actually
desired for the living room (e.g. 21 °C).
Press
to set the temperature for domestic hot water
mode.
Press
to set the temperature for heating mode.
Further settings for heating mode and domestic hot water
mode are described in the relevant sections.
If the basic display is shown, press
The functions that are available in the menu depend on
whether a system control is connected to the product. If you
have connected a system control, the settings for heating
mode must be available in the system control. (→ System
control operating instructions)
You can find additional assistance for the navigation under
MENU | INFORMATION | Menu introduction.
If there is an error message present, the basic displays
switches to the error message.
Validity: Product with control module
If the status display is shown, press
display.
You can see the set heating flow temperature on the status
display.
Flow temperature is the temperature at which the heating
water leaves the heat generator.
On the basic display, you can set the desired domestic hot
water temperature and desired room temperature (desired
heating temperature).
Press
to set the domestic hot water temperature.
Press
to set the room temperature.
Further settings for heating mode and domestic hot water
mode are described in the relevant sections.
If the basic display is shown, press
The functions in the menu that are available depending on
whether a control is connected to the product. If you have
connected a control, the settings for heating/domestic hot
water mode must be available in the control. (→ Control oper-
ating instructions)
You can find additional assistance for the navigation under
MENU | INFORMATION | Menu introduction.
If there is an error message present, the basic displays
switches to the error message.
4.1.2
Operating levels
If the basic display is shown, call up the menu in order to
display the end user level.
In the end user level, you can change and individually adapt
the settings for the product. The tables in the appendix list
the menu items and setting options that can be selected.
8000017440_FT Operating instructions
The installer level must only be operated by persons with
expertise and is therefore protected by a code.
4.2
4.2.1
1.
2.
3.
4.2.2
to call up the menu.
1.
2.
to call up the basic
4.3
1.
2.
3.
4.
5.
4.4
to call up the menu.
Validity: Product with control module
You can use a separate weekly planner in each case for:
–
–
–
Starting up the product
Opening the isolators
Ask the competent person who installed the product to
explain to you where these isolators are located and
how to handle them.
If installed, open the service valves in the heating in-
stallation's flow and return.
Open the cold-water isolation valve.
Switching on the product
Note
The product does not have an on/off switch. The
product is switched on and ready for operation
as soon as it is connected to the power grid. It
can only be switched off using the partition that is
installed on-site, e.g. fuses or circuit breaker in the
utility connection box.
Ensure that the product casing has been installed.
Switch on the product via the fuses in the utility con-
nection box.
◁
The "basic display" is shown in the product's oper-
ating display.
◁
The basic display also appears on the system con-
trol display.
Setting the language
Press
twice.
Navigate to the bottom menu item
pressing
.
Select the second menu item and confirm by pressing
.
Select the first menu item and confirm by pressing
Select the required language and confirm by pressing
.
Setting the time period using the weekly
planner
DHW mode
Circulation
Heating mode
and confirm by
.
191
Publicité
