Publicité
4.8
Transporting the product
Danger!
Risk of injury due to carrying heavy loads.
Carrying heavy loads can cause injuries.
▶
When transporting heavy products, ob-
serve all valid laws and other regulations.
1.
If the spatial conditions do not allow for the unit to be
inserted as a whole, separate the product into two
modules.
2.
Transport the product to the installation site. Use the
recessed handles on the rear and the carrying straps at
the front on the underside of the product as an aid.
4.8.1
Using the carrying straps
1.
Remove the front casing. (→ Page 213)
2.
To transport the unit safely, use the carrying straps on
the product's feet.
3.
If the carrying straps are located underneath the
product, swivel these out.
4.
Always transport the lower part of the product as
shown above.
212
5.
Always transport the upper part of the product as
shown above.
4.9
Separating the product into two modules
where necessary
1.
Remove the front casing (→ Page 213).
2.
Remove the upper side casing (→ Page 213).
3.
Swivel the electronics box to the side. (→ Page 214)
5
6
4x
4
3
2
4.
Slide the heat insulation (3) on the pipe transitions up-
wards.
5.
Pull out the clips (1) and (2) from the pipe connections.
6.
Disconnect the piping.
7.
Remove the plug (4) from the cylinder temperature
sensor.
8.
Remove four screws (5).
9.
Use the recessed handles to lift off the upper part (6) of
the product.
Installation and maintenance instructions 8000017440_FT
2x
2x
1
Publicité
