Connecting To The Proportional Valve - Burkert 8625-2 Manuel D'utilisation

5 COMMISSIONING
NOTE
Interference with the device is only allowed by specialist
personnel using suitable tools!
Before interfering with the temperature controller, always
switch off the voltage!
5.1

Connecting to the proportional valve

Fig.: Connecting the temperature controller to the proportional valve
Unscrew the 4 screws on the front panel of the temperature controller and
remove the cover carefully.
Place the housing of the temperature controller with the seal onto the valve.
Screw the temperature controller tightly to the valve.
ATTENTION!
Place the conver on the temperature controller and screw it tight with the 4
screws
ATTENTION!
8 - 8625-2 Standard
All manuals and user guides at all-guides.com
On screwing the temperature controller onto the proportional
valve, make sure the seal is correctly seated!
Make sure the cover is placed on the right way round
(pinned strips must engage in the sockets).