Utility Programmes - Corghi EM 9380 XLine Manuel D'utilisation

UTILITY PROGRAMMES

The Utility programmes are all the functions of the machine that are useful for its operation
but are not strictly connected to its normal operation.
Select the Utility and configuration programmes icon to display the list (menu) of the
utility programmes ;
Working environment programme
This wheel balancer allows three operators to work at the same time thanks to three dif-
ferent working environments.
- To call up a different working environment, select the working environments
icon.
- The following icons are displayed:
The lit icon shows the operator selected.
- Press the Enter button to select the icon desired .
- Press the Exit button to save the setting and exit
.
- The selection can also be seen in the working screen status line.
By selecting a new operator, the machine resets the parameters that were active at the last recall.
The stored parameters are:
- balancing mode; dynamic, ALU, motorcycle, etc.
- wheel dimensions: distance, diameter and width or those relating to the active ALU programme;
- OPT: last OPT.
The machine's general settings remain the same for all working environments: grams/ounces,
sensitivity x5/x1, threshold, etc....
FLASH OPT
Optimisation Programme
This procedure reduces the possible vibrations still present in running vehicles after an accurate
balancing. Based on our experiences, the programme can be recalled every time it is convenient
to minimise the running noise produced by the vibrations mentioned above.
The machine also indicates whether or not it is necessary to carry out the procedure by display-
ing the following icon in the status bar.
The calculations performed by this programme are based on the unbalance values measured
116 Operator's Manual EM 9380 XLine - EM 9380C XLine