Corghi EM 9380 XLine Manuel D'utilisation page 99

- if only one measurement is taken, the
machine interprets the presence of a rim
with balancing using a clip weight on both
sides (Dynamic Balancing Programme)
- moving the arm to the rest position, the
machine will set up for the manual WIDTH
entry.
- in this phase, it is possible to perform an
additional acquisition of the rim diameter
and distance.
- Measure the width of the rim using the
provided calliper (fig. 16).
- Change the displayed width value by in-
creasing or decreasing the value using the keypad.
After updating the wheel data the user can:
1) press the exit
to the new dimensions;
2) press the ENTER button to access the manual dimensions programme to convert and/
or change the wheel data.
- if two subsequent measurements are taken inside the rim on two balancing planes,
the machine interprets the presence of a rim with balancing using a clip weight on the
inner plane and an adhesive weight on the external one (ALU 2P). In this phase, the
machine could automatically change the type of weight on the inner plane from clip
to adhesive (ALU 1P).
Returning the arm to its idle position makes it possible for the operator to change this set-
ting, selecting and pressing the "enter" key
switches from ALU 1P to ALU 2P and vice versa.
Operator's Manual EM 9380 XLine - EM 9380C XLine
button to display the unbalance values recalculated according
ALU1P
. In this case, the balancing programme
16
UK
ALU2P
99