Configuration Programmes - Corghi EM 9380 XLine Manuel D'utilisation

- press the Enter
to confirm and switch to the
distance value entry phase;
- change the value of the distance
displayed by entering that in-
dicated on the internal sensor
(A, fig.25) using the keypad;
- press the exit
to terminate the manual data
setting.
Automatic locking device C opening/closure function
If the control pedal C is not working (M, Fig.8), the locking system C can be opened/closed
as follows:
- Select the
- press enter to open or close the automatic locking system C.
This function can be inserted in the bar of the main icons, as explained in Preferred
programme configuration.

CONFIGURATION PROGRAMMES

The Configuration programmes are those functions that are intended for customising the
machine's operation and are normally executed when the machine is installed.
The list of the configuration programmes can be displayed as follows:
- Select the utility and configuration programmes icon
- Select the configuration programmes
Automatic Position Search (RPA) Configuration
Enables/disables the automatic positioning of the wheel at the end of the spin. After the
list of the setting programmes is displayed, proceed as follows:
- Select the Automatic position search configuration (RPA) icon
The following icons are displayed:
Operator's Manual EM 9380 XLine - EM 9380C XLine
button
button
icon;
;
icon;
25
UK
.
123