Corghi EM 9380 XLine Manuel D'utilisation page 100

DETECTION PLANS BY
POINTER LASERBLADE
The detection of the geometrical data relative to the real
balancing planes for the application of adhesive weights,
can be facilitated by the laser line on the lever of the au-
tomatic detector.
To enable this line it is necessary to press the button on the
automatic arm (A, Fig.16a).
The laser line is thus visible inside the rim for 10 seconds,
after which, if necessary, the button on the automatic arm
must be pressed again.
Wheel data entry for wheel balancers with an ultrasonic sensor
To enter the distance, diameter and width values automatically, proceed as follows:
- bring the automatic internal measuring arm into contact with the inner side of the rim
(fig.15). Take great care to position the arm correctly so as to ensure accurate data read-
ing.
- Keep the arm in contact with the rim until the machine has acquired the wheel's diameter
and distance values. The following screen appears during this phase:
100
(IF PRESENT)
(if installed)
Operator's Manual EM 9380 XLine - EM 9380C XLine
16a