Corghi EM 9380 XLine Manuel D'utilisation page 117

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

during the last spin performed which must therefore refer to the wheel being serviced.
Proceed as follows to recall this programme:
- Select the OPT Flash icon
OPT STEP 1
1.
take the valve to 12 o'clock;
2.
press Enter
OPT STEP 2
3.
turn the wheel until the valve gets to 6 o'clock position (the bottom arrow turns from red
to green);
4.
make a chalk mark on the tyre external side at 12 o'clock;
5.
confirm you marked the tyre by selecting Enter
6.
remove the wheel from the wheel balancer.
7.
Turn the tyre on the rim until the mark made matches the valve (180º rotation).
8.
Refit the wheel on the wheel balancer and confirm the operation described in points 6
and 7 by selecting enter
Then, following the new indications on the monitor:
9.
Turn the wheel until the valve gets to 12 o'clock position:
10. press the Enter button
11. perform a spin.
Now, the real unbalance values of the wheel thus mounted on the wheel balancer are displayed.
Take the wheel to the position shown on the monitor. The foreseen unbalances are displayed
by performing the matching and the proportional improvement which can be obtained if the
user decides to continue the optimisation procedure.
In case optimising is insufficient, or significant improvements cannot be obtained, select the
Exit key
twice (first to exit the procedure and restart the menu, and then to exit the
programme permanently); perform a spin to balance the wheel; otherwise, the system goes to
the third and final programme phase.
OPT PHASE 3
Following the indications on the monitor:
12. turn the wheel up to the position shown on the position indicator;
13. make a double mark on the outer side of the tyre at the 12 o'clock position with a piece
of chalk. If the screen indicates that the tyre should be switched around on the rim, make
a double mark on the inner side using a piece of chalk.
14. confirm you marked the tyre again by selecting Enter
Operator's Manual EM 9380 XLine - EM 9380C XLine
to confirm the operation;
;
to confirm the execution;
;
;
UK
117

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Em 9380 c xline

Table des Matières