Corghi EM 9380 XLine Manuel D'utilisation page 97

screw the C hub manually until it reaches
the end position.
- Tighten the C hub by inserting the special
C key in the C hub slot (fig.14).
- Remove the split pin from the cylindrical
protection bush.
- To adequately tighten the hub must be
given a hammer blow on the special key
C (you can also use the pliers, hammer
side, to fix the spring-loaded weights).
If during the assembly phase the hub C should
freeze before completing the tightening
phase, proceed as follows:
- Make a complete turn in the opposite direc-
tion of the hub C
- Remove the split pin B
- Push the hub C in the direction shown in
figure 14a and then tighten the hub until
it stops.
IMPORTANT
During the tightening phase, check that the ratch-
ets are always closed inside the locking sleeve.
IMPORTANT
In case of failure of the automatic locking device,
it is possible to remove the wheel that may be
present on the machine acting on the rear side
of the body as indicated in Figure 14b:
Operator's Manual EM 9380 XLine - EM 9380C XLine
13
14
14a
UK
14b
97