OmniPod DASH Guide De L'utilisateur page 87

6 Modifying Basal Insulin Delivery
2. Tap the Basal Rate field and enter the
desired change in the basal rate:
• If temp basals are configured as a
percentage (%) change, scroll the
wheel up or down to define the
per cent change to the active Basal
Program. An up arrow indicates
increasing the basal rate above
that of the active Basal Program. A
down arrow indicates decreasing
the basal rate below that of the
active Basal Program.
• If temp basals are configured as a
flat rate (U/hr), scroll the wheel to
select the basal rate for the entire
temp basal period.
To change whether temp basals are
configured as percent (%) or U/hr, see
"Temp basal" on page 105.
Note: The scroll wheel will not scroll above your Maximum Basal Rate. To
adjust your Maximum Basal Rate, see "Maximum Basal Rate" on page 104.
Tip: You can turn off insulin delivery for the duration of the temp basal
by setting a decrease of 100% or setting the temp basal to 0 U/hr. For more
information, see "Temp basal limitations" on page 141 and "Methods to
temporarily stop insulin delivery" on page 142.
3. Tap the Duration field and enter the temp basal duration (between 30
minutes and 12 hours).
Examine the temp basal graph at the top of the screen. The proposed temp
basal is superimposed on the active Basal Program.
• The lighter blue shaded area shows the proposed temp basal rate for each
segment.
• If you set a decrease, the active Basal Program is shown as a dotted line.
4. Tap CONFIRM to continue.
5. Review the temp basal details. If corrections are needed, tap on the row that
you would like to change. Then enter your corrections and confirm them.
Note: If necessary, the PDM limits the basal rate of any segment that would
exceed your Maximum Basal Rate setting. This is indicated by a red line on
the graph and the word 'Max'.
6. To activate the temp basal, tap ACTIVATE. Then tap ACTIVATE again.
70
Effective Date: 18OCT2020, PCO-000235