OmniPod DASH Guide De L'utilisateur page 45

2 Initial PDM setup
Define the first segment
1. The Start Time for the first segment is always midnight. Tap the End Time
field and scroll to select the desired end time.
2. Tap the Basal Rate field and scroll to select the basal rate for the segment.
The Maximum Basal Rate that you entered earlier is displayed under the
Basal Rate text. You cannot enter a basal rate greater than this number.
Note: The two vertical blue lines on the graph near the top of the screen show
the start and end time for the basal segment. The selected basal rate for the
segment is shown between the two vertical lines.
3. Check the values of your start and end times and the basal rate. Then tap
NEXT.
Define additional segments
If the Basal Program does not cover 24 hours, you must add additional segments:
1. Tap the End Time field and select the duration of the next segment.
2. Tap the Basal Rate field and select the basal rate for the segment.
3. Review the segment details and the graph.
4. Tap NEXT to move to the next segment.
5. Repeat the preceding steps as needed until your final segment ends at
midnight.
28
Effective Date: 18OCT2020, PCO-000235