OmniPod DASH Guide De L'utilisateur page 62

1. Tap RECORD POD SITE to bring up the Record Pod Site screen.
2. Tap the FRONT or BACK tab to select an area of your body for your Pod. To
help you avoid recent Pod sites, the screen indicates the two most recent dates
that each site was selected.
3. Tap a circle to indicate the location on your body where you will place your
new Pod. A blue dot appears inside the selected circle. Tap again to deselect
the location.
4. Tap the DETAILS tab to add a detail about the placement of this Pod. For
example, you could add a detail that says 'Facing up' or 'Facing down' to
describe the Pod's orientation.
a. To add a new detail, tap ADD NEW and type in the new detail. Tap ADD
when finished. The new detail is added to the list.
Note: The PDM considers uppercase letters and lowercase letters to
be identical. For example, you can only use one of the following details:
'Facing up', 'FACING UP' or 'facing up', because the PDM considers these
to be identical entries.
b. Select a detail for the new Pod by tapping the circle next to that detail. You
may only add one detail for each Pod. Tap again to deselect the detail.
Note: To delete a site detail, tap the
5. Tap DONE when finished to return to the Change Pod screen.
Changing your Pod 3
next to the detail.
Effective Date: 18OCT2020, PCO-000235
45