Lenze 8200 Vector Instructions De Montage page 153

8
Fault detection and elimination
Fault messages
LED's at the drive controller (status display)
LED −36− Operating status
 ‚
red green
off on Controller enabled
on on Mains switched on and automatic start inhibited
off slowly blinking Controller inhibited
off fast blinking Motor parameter identification
fast blinking off Undervoltage switch−off
slowly blinking off Fault active, check under C0161
1

8888
‚
88888
Hi
Lo
3 4
X3
OFF
20 28
Reset the drive controller in this way if a fault occurs (TRIP reset):
1. Plug the keypad onto the AIF interface during operation.
2. Read and take down fault message on the keypad display.
3. Inhibit controller.
4. Disconnect controller from the mains.
5. Carry out a fault analysis and eliminate the faults.
6. Restart the controller.
152
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
2

8
PS
888
m
Hz V A 880Hr
%sh Ω °C
rpm
Hi
Lo
‚
5
EDK82EV113 DE/EN/FR 8.1
1
PS
01 61
000
m
Hz V A
%sh °C
Ω
rpm
6
ON
82vec355
L