Operation Of The Machine - Textron RANSOMES WH Serie Manuel De Fonctionnement

GB-NL-F-26
Fig.15
OPERATION OF THE
MACHINE
Read the Safety Instructions.
BEFORE OPERATING FOR THE FIRST TIME
l
Check and adjust tyre pressure, if necessary, to
9 psi 250, 305 / 14psi 405.
l
Add diesel fuel (Fig.15).
l
Check engine oil and top-up, if necessary.
l
Check radiator coolant and top-up, if necessary
(50% antifreeze solution).
l
Make sure you understand the information
contained in the preceeding General Instructions
and Instruments & Controls sections.
STARTING THE ENGINE
Following is the procedure to use for a cold engine.
1. Ensure the cutting units are disengaged (see
cutting unit switch in CONTROLS), the FWD/
RVS pedal and associated Neutral Latch control
are not depressed and the throttle setting is in a
mid position.
2. Turn the ignition switch all the way counterclock-
wise and hold until the glow plug light goes off
(5-10 sec.)
3. Turn ignition key fully clockwise to the start
position and operate the starter motor until the
engine starts (should only take a few seconds)
4. When the engine starts, release the key immedi-
ately and it will return to the RUN position.
5. If the engine does not start, preheat the glow
plugs and try again.
NOTES:
Warm engine - When the engine is warm
l
because of surrounding temperature or recent
operation, step No.2 of the cold engine starting
procedure may be skipped (no need to preheat
glow plugs).
l
If the engine fails to start after two tries (with
preheat if necessary), wait 20 seconds and try
again.
l
The starter motor should never be run continu-
ously for longer than 30 seconds or it may fail.
GB