Repair; Taking Out Of Service; Information For Energy Saving - Franke Frames FS 913 M Manuel D'utilisation

Masquer les pouces Voir aussi pour Frames FS 913 M:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

The oven uses a special enamel which is easy
to keep clean. However, Franke recommends
to clean it frequently in order to avoid baking
on grime and previous cooking residues.
Do not use harsh abrasive cleaners or
Z
X
sharp metal scrapers to clean the oven
door glass since they can scratch the
surface, which may result in shattering of
the glass.
Do not use steam cleaners or direct jets of
Z
X
water.
Risk of electric shock due to entering
liquid!
The device contains electrical components.
Make sure that no liquid enters the interior
Z
X
of the device.
Do not use pressurised steam to clean the
Z
X
device.
Do not use a wet cloth to clean the
Z
X
operating elements.

INFORMATION FOR ENERGY SAVING

The operating modes GENTLE HEAT and HOT AIR
consume less energy than the other cooking functions
available.
Avoid frequent door opening.
Z
X
Preheat as rapidly as possible.
Z
X
Preheat the oven chamber only if the baking
Z
X
results depend on this operation.
If a recipe for a gratin uses residual heat for
Z
X
longer than 30 minutes, turn the appliance off
5–10 minutes before the end of cooking.
FS 913 M / FS 913 P

Repair

Do not allow anyone except qualified
Z
X
personnel to install or repair the appliance.
Contact a service centre authorised by the
Z
X
manufacturer or qualified personnel in the
following cases:
– Immediately after unpacking, in the event
of doubts regarding the integrity of the
device
– During installation (according to the
manufacturer's instructions)
– Doubts regarding the correct operation of
the device
– Malfunction or poor operation
– Replacing the power socket if incompatible
with the power plug of the device
– If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.

Taking out of service

If the oven is no longer to be used, call the
Z
X
service centre or qualified personnel to
disconnect it from the power supply.
– 7 –
EN

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Frames fs 913 p

Table des Matières