Fitting Instructions - MSA V-EDGE CNB/P/11.060 Manuel D'utilisation

Fitting instructions

The V-EDGE PFL attachment bracket allows connection to the MSA V-FORM
rear D-ring. The bracket shall only be used to connect the V-EDGE PFL to the harness. Any other devices shall be
connected directly to the harness D-ring.
To install the V-EDGE PFL to a full body harness:
Lift the rear dorsal D-ring on the harness and pull the webbing straps through the dorsal D-shim until there is
1
suf cient space to feed the attachment pin between the webbing and dorsal D-shim.
Pull the (green) knurled knob on the left side of the bracket and then rotate it counterclockwise. Pull the (green) harness
2
connector pin on the right to open the bracket.
Place the bracket arms over the torso straps of the harness and feed the (green) harness connector pin behind the
3
torso straps. When the harness connector pin is fully engaged, no red marking shall be visible on the pin.
Pull the harness straps back through the dorsal pad to eliminate slack in the webbing.
4
Following installation, and prior to use, the V-EDGE PFL shall be inspected by a second user.
1. Ensure the harness connector pin is passed behind both harness webbing straps between two slots in the dorsal
D-shim.
2. Ensure the harness connector pin is fully housed through both bracket arms and locked in position; no red marking shall
be visible on the pin.
3. Ensure the V-EDGE PFL is installed in the correct orientation, such that the Energy absorber pouch hangs below
the attachment bracket.
4. Ensure both harness straps are pulled tight and equally through the dorsal D-shim.
1 1 1
3
2
4
™ and V-FIT ™ harnesses just below the
GB
31