Setup Procedure - Spektrum BEAST X AR7210BX Mode D'emploi

Binding
You must bind the receiver to the transmitter before the receiver will operate. Binding is the
process of programming the receiver to recognize the GUID (Globally Unique Identifier) code
of a single specific transmitter.
To bind a Spektrum AR7210BX to a DSM2 or DSMX transmitter:
1. Insert the bind plug in the BIND/DAT port on the
receiver. Connect the receiver battery to any of the
other ports. When using a heli with an ESC that powers
the receiver, connect the controller to THRO port.
2. Power on the receiver. The H LED on the Spektrum
AR7210BX and external remote receiver (if connected)
should be flashing, indicating the receiver is in bind mode.
3. Move the throttle stick to desired failsafe position
(throttle low).
4. Follow the procedures of your specific transmitter to enter Bind Mode. The system will connect
within a few seconds. Once connected, the H LED will turn off and the Spektrum AR7210BX will
start the initialization process.
5. Remove the bind plug from the BIND/DAT port on the receiver and store the bind plug in a
convenient place.
NOTICE: Remove the bind plug to prevent the system from entering bind mode the next
time the power is turned on.

Setup Procedure

First, power on the transmitter. The Spektrum AR7210BX initializes when the receiver is powered
on. Do not move the Spektrum AR7210BX or the helicopter while the receiver is initializing.
Receiver Initialization Cycle
1. LEDs H through N cycle to initialize the receiver inputs.
2. LEDs A through G cycle to calibrate the sensors.
3. The swashplate jumps twice and the Status LED turns solid after initialization. This
indicates the active tail gyro mode.
Status-LED
Purple Solid
Blue Solid
NOTICE: If using SAFE
status for 8 seconds. During this time the Status LED will light up red.
Status-LED
Red Solid
Blue Solid
4. One of the LEDs A through N will light for 8 seconds to show the amount of tail gain or
the current SAFE status and gain. A = 0% to N = 100%.
Tail gyro is in Normal-Rate mode
Tail gyro is in Heading Lock mode
technology, the system will show the active SAFE
®
Menu LEDs indicating current SAFE® status and gain
Tail gyro is in Heading Lock mode
9
AR7210BX with bind plug
inserted
technology
®
EN