Parameter Menu - Spektrum BEAST X AR7210BX Mode D'emploi

Parameter Menu

To enter the Parameter Menu:
1. When the Spektrum AR7210BX is ready for flight, press and hold the setup button
until the LED flashes next to Menu Point A.
2. Release the setup button.
3. Press the setup button once to move to the next menu point.
4. Press the setup button once at at the last Menu Point to exit the Parameter Menu.
It is possible to skip menu points. Do not move the transmitter sticks when you are in a menu
point you want to skip. Quickly press the setup button again to move past the menu point you
want to skip.
CAUTION: Never fly the helicopter when the Spektrum AR7210BX is in the
Setup or Parameter Menu. Gyro control and transmitter stick controls are
disabled when the Spektrum AR7210BX is in the Setup or Parameter Menu.
A Quick Trim
NOTICE: Never use transmitter trims with the Spektrum AR7210BX.
The Spektrum AR7210BX will interpret the trim as a control command, NOT as servo trim. There
is one exception: The rudder servo can be trimmed on the remote control when the tail gyro is
operated in Normal-Rate mode. Note, however, that this trimming should only be temporary as
the AR7210BX calibrates the stick center positions during every initialization process. Thus, on
the next flight the servo would be back on center position despite trimming in the transmitter.
The first menu point of the Parameter Menu gives you the possibility to easily adjust your
servo center trim on the flying field as for instance your helicopter does slowly drift in hovering
flight or when it doesn't climb out straight on collective pitch inputs.
Swashplate Servos
Parameter Menu Point A adjusts both the aileron and elevator servo centers without regard to
the individual servos.
To adjust the aileron and elevator servo centers:
1. Move the aileron or elevator stick in the desired direction.
2. Repeatedly move the stick or hold the stick to move several trim steps at once.
3. To delete the trimming, move the tail stick in any direction.
IMPORTANT: Unlike digital trims in the transmitter, Menu Point A is not a separate trim
function. If the new center position is saved once in Parameter Menu Point A, it will also
change the servo center position in Setup Menu Point G.
Once the center position is saved in Menu Point A, it is no longer possible to
delete the trimming.
35
EN