Spektrum BEAST X AR7210BX Mode D'emploi page 50

EN
If SAFE technology works reversed, e.g. one of the Menu-LEDs B through N lights up when
®
the switch for SAFE
independant of the servo throw when the switch is in "on"-position, then simply reverse the
channel for SAFE
SAFE® Technology with Combined Switch Channel
The tail gyro gain channel is also used for SAFE
SAFE technology is off, the channel deflection determines the amount of tail gyro gain as
®
usual. Increase or decrease the (servo) travel of channels to adjust the tail gyro gain. The
amount of tail gyro gain is indicated by the yellow Menu-LEDs each time after initialization
procedure and always when the gain changes. Here the Status LED lights up Blue. When you
flip the switch and the channel is deflected to the other direction, the Spektrum AR7210BX will
keep the current tail gyro gain and activate SAFE
Red. When adjusting the height of deflection of the channel into this direction you can specify
the SAFE technology gain by adjusting the servo travel. So here one channel is used for two
®
functions. Depending on the direction you can either adjust tail gyro gain or SAFE
gain and by switching between directions SAFE
When using SAFE
SAFE technology is at least deactivated once before take off. Otherwise the
®
tail gyro gain would be minimal as the system would not have been able to determine your
tail gain adjustment after initialization.
In this mode it is absolutely necessary to use a switch that changes the control directions
directly and without intermediate steps. In particular, do not use a slider on the transmitter!
Otherwise, when you activate SAFE
0% before the system turns on the SAFE
when SAFE technology is active.
®
HeadingLock-Mode
(Status-LED: blue)
SAFE® Technology off
(Status-LED: red)
100%
The tail gyro Rate-Mode is only available when SAFE® is operated with Separate Switch Channel.
technology is in "off"-position and the Menu-LED A does not disappear
®
technology in your transmitter by using the servo reverse function.
®
technology with combined switch channel make sure
®
technology the tail gyro sensitivity would be decreased to
®
Tail gyro gain channel
technology. In the switch position where
®
technology. Here the Status LED lights up
®
technology is activated or deactivated.
®
technology. So you would have 0% of tail gyro gain
®
Menu-LEDs
A
A
0%
50
technology
®
SAFE® Technology on
(Status-LED: red)
-100%