Spektrum BEAST X AR7210BX Mode D'emploi page 44

EN
K RPM Governor — Quick Change Rate
If the RPM Governor is enabled and you increase the preset rotor head speed there will not
be an abrupt change but the system will increase the rotor RPM with a given spool up rate
that can be set at Menu Point K. This rate also determines how fast the rotor head speed will
increase when reactivating the RPM Governor after an autorotation maneuver. In this case the
normal soft start would take too much time until the rotor has reached full speed and on the
other hand it would not be necessary as typically the rotor is still turning at some speed when
performing an autorotation.
Status-LED
OFF
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
If you don't need the autorotation spool up you can set to "same as initial spool up rate."
The spool up rate will then be the same as set at Menu Point J. So effectively there is no
difference if you spool up from an initial state when the RPM Governor gets activated for the
first time or when you reactivate the RPM Governor from autorotation.
NOTICE: If the spool up rate is high, always ensure the rotor blade bolts are properly
secure or throttle fluctuations may cause damage to the main gear. In nitro helicopters,
throttle fluctuations may cause stalling.
Select "user defined" to choose a custom value that can be edited by using the StudioX
software and the optional USB2SYS interface.
Press the button to save the configuration and to proceed to Menu Point L if SAFE
is installed on your device. Otherwise pushing the button will exit the Parameter Menu.
Quick Change Rate
User Defined
same as initial spool up rate
300 RPM/s
500 RPM/s*
700 RPM/s
900 RPM/s
44
*
Factory setting
technology
®