Spektrum BEAST X AR7210BX Mode D'emploi page 12

EN
B Swashplate Servo Frequency
CAUTION: If you do not know the maximum pulse rate for your servos, do not
exceed 50Hz servo frequency. A higher servo frequency can lead to servo failure.
Analog servos usually tolerate a maximum of 50Hz. Contact the servo manufacturer
if you are unsure of the servo frequency.
Always use the highest servo frequency that the servos can handle for the best performance.
Status-LED
OFF
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
Press the setup button to save the selection and move to Menu Point C.
To see a complete Spektrum servo reference chart, refer to the servo chart on spektrumrc.com.
C Tail Servo Center Position/Pulse Length
Almost all tail servos work with 1520µs (micro seconds). There are a few tail servos available that
use a different center position pulse length.
Status-LED
OFF
Purple Solid
Red Solid
Blue Solid
IMPORTANT: If a pulse length is selected C that does not allow a certain tail servo
frequency D, the frequency is automatically reduced. The center position pulse setting
always has priority. A servo can operate without issue at a lower frequency but cannot
operate with an incorrect center position pulse length.
Press the setup button to save the selection and move to Menu Point D.
User Defined (requires PC software)
50Hz*
65Hz
120Hz
165Hz
200Hz*
Tail servo center position pulse length
User Defined (requires PC software)
960µs
760µs
1520µs*
*
Factory Setting
*
Factory Setting
12