Spektrum BEAST X AR7210BX Mode D'emploi page 18

EN
L Adjusting the Cyclic Swashplate Limit
Menu Point L adjusts the maximum possible tilting of the swashplate for aileron and elevator.
The deflection is limited in a circular path, similar to a cyclic ring function, preventing swashplate
binding at full aileron and elevator travel.
1. Carefully move the sticks for aileron, elevator and pitch elevator and pitch to all maximum
endpoints simultaneously. Watch for binding or lack of movement in the swashplate,
linkage rods and servos.
2. Move the rudder stick right or left to increase or decrease the aileron and elevator throw
limiter. Always try to achieve the maximum possible cyclic throw without causing binding at
any servo position.
3. The Status-LED should still be
Status-LED is Purple
available throw.
IMPORTANT: If you make any modifications to Menu Points G, J or K in the future,
you must repeat Menu Point L again.
4. Press the setup button to save the selection and move to Menu Point M.
M Setting the Swashplate Sensor Directions
1. Tilt the helicopter forward. The swashplate should tilt backward.
2. Tilt the helicopter backward. The swashplate should tilt forward.
3. Roll the helicopter left. The swashplate should roll right.
4. Roll the helicopter right. The swashplate should roll left.
5. If the swashplate does not move in the correct direction, reverse the sensor direction by
moving the rudder stick to select one of the four following options:
Status-LED
OFF
Purple Solid
Red Solid
Blue Solid
6. Repeat Step 5 until both sensors are working in the correct direction.
7. Press the setup button to save the selection and move to Menu Point N.
Blue when the swashplate is at the maximum limit. If the
or OFF, you must mechanically adjust the helicopter to increase the
Elevator
Reversed
Reversed
Normal
Normal*
Aileron
Reversed
Normal
Reversed
Normal*
*
Factory Setting
18