Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
Status-LED
OFF
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
The option "User Defined" allows you to define your own settings using the optional PC Software.
Press the setup button once to move to Parameter Menu Point I.
I RPM Governor — Throttle Response
If the Governor Mode is "deactivated," skip through the following Parameter Menu points by
Pressing the setup button at Menu Points I, J, and K.
Use Menu Point I to change the response of the RPM Governor. This determines how
fast and hard the system will open the throttle when the rotor RPM changes. Ideally the
response is set as high as possible. If it is too low the main rotor may speed up immediately
in unloaded conditions, e.g. when the helicopter is descening and the RPM Governor will
only give soft throttle inputs when the head speed decreases. If the response is set too high
on the other hand, the throttle may stutter audible and/or the motor RPM will kick in very
hard and overshoot after the rotor head was loaded and the RPM decreased. The height of
throttle response highly depends on factors such as heli size (blade size), motor power and
performance and/or the throttle reponse behavior of the speed controller (when flying an
electric heli). If you need to adjust the throttle response, we recommend to start with the lowest
value and increase accordingly.
Having a heli with good motor power and/or a fast responding speed controller (on electric
helis) typically allows to have high throttle response values (up to "aggressive" setting) which
will give very consistent head speed. Helis with not so much power (small nitros, gasser, scale
helis) prefer low throttle response settings for a softer throttle management.
Status-LED
OFF
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
Press the button to save the configuration and to proceed to Menu Point J.
Pitch Boost
User Defined
Off*
Low
Medium
High
Very High
Throttle Response
Slow
Normal
Slightly increased*
Increased
Fast
Aggressive
*
Factory setting
*
Factory setting
42
Publicité
Table des Matières
