Spektrum BEAST X AR7210BX Mode D'emploi page 16

EN
Status-LED
OFF
Purple Solid
Red Solid
Blue Solid
IMPORTANT: Menu Point I does not have a time limit. If the servos are still not reacting
properly after using servo reverse, make sure the servos are connected to the proper receiver
channels. Also, make sure any servo mixing in your transmitter is turned off.
6. Press the setup button to save the selection and move to Menu Point J.
J Teaching the Cyclic Pitch Geometry
CAUTION: Do not touch any stick on your transmitter when entering Menu Point J.
This will cause unwanted flight behavior.
1. Move the rotor blades so that they are parallel to the tail boom.
2. Attach a pitch gauge to a rotor blade. The swashplate should be in the neutral position and
the blade should have 0° of pitch. If the swashplate is not neutral with 0° of blade pitch,
repeat Menu Point G before proceeding.
3. Move the aileron stick left or right until the pitch gauge has exactly 6° of cyclic pitch. Then
release the aileron stick.
4. If the pitch gauge has more than 6° of cyclic pitch, move the aileron stick in the opposite
direction until the pitch gauge is at 6°.
IMPORTANT: The Status LED should light up
Red, Purple or OFF, you must change the mechanical setup of the helicopter. Otherwise the
system may not perform well and you may loose control of the helicopter. You can use:
a) Shorter servo horns
b) Shorter linkage balls on the inner swashplate ring or
c) Longer blade grip linkage levers
5. Press the setup button once to save the cyclic pitch adjustment and move to Setup Menu
Point K.
CH1 CH2
Normal Reverse
Normal* Normal*
Normal Reverse
Normal Normal
CH3
Reverse
Reverse*
Normal
Normal
*
Factory Setting
Blue at 6° of cyclic pitch. If the Status LED is
16