Setup Menu - Spektrum BEAST X AR7210BX Mode D'emploi

Exiting the Menu
When the last menu point of each Menu Level is reached, quickly press the setup button to
exit the menu. The Spektrum AR7210BX will also automatically exit the menu after 4 minutes of
inactivity. The Spektrum AR7210BX will not automatically exit at points D, G, I and J to
allow time for mechanical helicopter adjustments.
CAUTION: Never fly the helicopter when the Spektrum AR7210BX is in the Setup
or Parameter Menu. Gyro control and transmitter stick controls are disabled when the
Spektrum AR7210BXis in the Setup or Parameter Menu.
Factory Reset
Unplug all servos and remove the servo horns before resetting the Spektrum AR7210BX.
To erase all Spektrum AR7210BX settings:
At any menu point during the Setup menu (A through N), press and hold the setup button for
at least 10 seconds until LEDs A through N quickly flash to confirm the reset.
Any previous programming is deleted during a reset and default to factory settings.
CAUTION: Do not attempt to fly the helicopter without doing a complete setup
procedure after a reset. If you do not complete the setup, the helicopter will crash,
causing property damage and injury.

Setup Menu

A Mounting Orientation of the Spektrum AR7210BX
At Setup Menu Point A you must select the exact mounting position of the Spektrum
AR7210BX in your helicopter. This results in eight possible settings for Setup Menu Point A:
Status-LED
OFF
Purple Flashing
Purple Solid
Red Flashing
Red Solid
Blue Flashing
Blue Solid
Red/Blue
Mounting Orientation
Flat, sticker on top side, socket points in forward flight direction*
Vertical, button is on the top, socket points in forward flight direction
Flat inverted, sticker on bottom side, socket points in forward flight
direction
Vertical inverted, button is on the bottom, socket points in forward
flight direction
Flat, sticker on top side, socket points to the tail boom
Vertical, button is on the top, socket points to the tail boom
Flat inverted, sticker on bottom side, socket points to the tail boom
Vertical inverted, button is on the bottom, socket points to the tail boom
11
EN
*
Factory Setting