Spektrum BEAST X AR7210BX Mode D'emploi page 48

EN
If the maximum positive/negative pitch angle is changed at Setup Menu Point K then
also the hovering pitch will change! So after re-adjusting the maximum angles also
check and re-adjust the hovering pitch at Parameter Menu Point M.
When using the "3D — Mode with pitch control" make sure that the pitch range is
symmetrical, i.e. the maximum positive and negative pitch angles are of same size.
Otherwise the hovering pitch will differ in normal and inverted position as the hoving
pitch is calculated from the maximum pitch! The setting at Parameter Menu Point M
affects both directions. A separate adjustment of the hovering pitch angles is not provided.
Channel Assignment Menu
By default, the Spektrum AR7210BX and all additional features can be operated with a
6-channel transmitter. If desired, and a transmitter with 7 or more channels is used, SAFE
technology can be operated with a separate channel and you can assign a separate switch
channel for the Nitro Governor instead of controlling the RPM Governor by throttle channel.
Teaching the additional channels is done in the "Channel Assignment Menu":
1. Press and hold the push button on the Spektrum AR7210BX unit and power it on.
Menu LED A will flash instantly, the Status LED will either be
signal) or
2. At Menu Point A, the switch channel for the nitro RPM governor can be assigned.
Move the specific channel (switch or knob), the
indicate the channel has been detected. Then press the button to proceed to Menu Point
B. If you don't want to assign a separate channel, either you don't need this function
at all or if you want to use the throttle channel to control the governor, don't move any
channel but simply skip this assignment by briefly pressing the button.
3. At Menu Point B, you can assign your separate channel for switching SAFE
technology. Here again you can simply skip by Pressing the button and keep the
default setting (using combined mode with gear channel).
For these functions you can assign any channel from AUX2 to AUX6. Note that it is not possible
to assign both functions to the same channel. Also note that the specific AUX output on the unit
cannot be controlled by this channel then. Instead as a side effect the channel output will be
mapped to the next free channel internally, i.e. when not using the governor function and you
assign channel AUX2 to control the SAFE
mapped to the transmitter' s AUX4 channel.
Blue (transmitter signal is there). Release the button.
Blue
technology, the AUX2 output on the unit then will be
®
48
Red
(no transmitter
Status LED will flash shortly to
®
®