Spektrum BEAST X AR7210BX Mode D'emploi page 49

Usage of SAFE
Once SAFE technology was enabled by choosing one of the five SAFE
®
at Parameter Menu Point L, SAFE
by using the switch on the transmitter whose channel was assigned as actuator for SAFE
technology in Receiver setup menu. When the Spektrum AR7210BX is ready for operation
check whether activation of SAFE
Similar to the tail gyro gain display you can determine the status of SAFE
watching the yellow Menu-LEDs. These light up each time after the initialization sequence
as well as when the amount of SAFE
technology is activated/deactivated. To distinguish the tail gyro gain display from SAFE
technology the Status-LED lights up in red color when the status of SAFE
displayed. When SAFE
Menu-LEDs B through N lights up, SAFE
signal the amount of SAFE
for the SAFE technology is, the farther the Menu-LED will go in the direction of point N
®
and the stronger the effect of SAFE
fast and violent the helicopter will be rotated back to horizontal position. For the first flight it
is recommended to adjust the throw of the SAFE
G lights up when SAFE
below typically you can set the gain even higher (until Menu-LED I lights up).
SAFE Technology off
®
(Status-LED: red)
-100%
SAFE®Technology with Separate Switch Channel
SAFE technology activation and strength can also be programmed to a separate switch on
®
7+ channel Spektrum transmitters, using any channel assignable to a 2-position switch,
AUX2 and higher. Travel and direction of the SAFE
SAFE technology is active or not and how strong it reacts. A deflection into one direction
®
will activate SAFE technology. Typically Menu-Led N (maximum gain) will light up when
®
activating SAFE technology for the first time, as the travel of the channel will be 100%. Adjust
®
the deflection of this channel, i.e. by reducing the servo travel in the transmitter, so that one
of the Menu-LEDs lights up next to point G (or point I when using a small helicopter) as
described previously.
When the switch channel is moved into the other direction Menu-LED A will light up and
flash. In this case SAFE
i.e. the switch is placed in the other direction, the status LED remains momentarily Red, and
the Menu-LED flashes next to point A to confirm deactivation.
Technology
®
technology can be activated and deactivated in flight
®
technology works as expected:
®
technology gain is changed respectively when SAFE
®
technology is deactivated Menu-LED A starts to flash. If one of the
®
technology gain. The larger the deflection of the switch channel
®
technology will be. In particular this determines how
®
technology is activated. If using a small helicopter like 450 size or
®
A
0%
Switch channel for SAFE® technology
technology is deactivated. When SAFE
®
technology is active. The individual Menu-LEDs
®
technology channel just until Menu-LED
®
SAFE
technology channel determine whether
®
49
technology types
®
technology by
®
technology is
®
Technology on
®
(Status-LED: red)
technology is deactivated,
®
EN
®
®
®
100%