TSM DURASWEEP 115 Mode D'emploi page 32

  
Do not take current samples from the batteries using pliers, sockets and provisional contacts. Do not take current samples from the batteries using pliers, sockets and provisional contacts. Do not take current samples from the batteries using pliers, sockets and provisional contacts.
  
Make sure all connections (cable terminals, sockets, plugs, etc.) are always well tight and in good conditions Make sure all connections (cable terminals, sockets, plugs, etc.) are always well tight and in good conditions Make sure all connections (cable terminals, sockets, plugs, etc.) are always well tight and in good conditions
  
Do not rest metal tools on the batteries. Do not rest metal tools on the batteries. Do not rest metal tools on the batteries.
  
Keep the batteries clean and dry, if possible using antistatic cloths. Keep the batteries clean and dry, if possible using antistatic cloths. Keep the batteries clean and dry, if possible using antistatic cloths.
  
Top up with distilled water every time the level of the electrolyte falls to 5 - 10 mm from the splash guards. Top up with distilled water every time the level of the electrolyte falls to 5 - 10 mm from the splash guards. Top up with distilled water every time the level of the electrolyte falls to 5 - 10 mm from the splash guards.
  
Avoid overcharging and keep battery temperature below 45 - 50° C. Avoid overcharging and keep battery temperature below 45 - 50° C. Avoid overcharging and keep battery temperature below 45 - 50° C.
  
Maintain any centralised topping-up systems in good working order and service regularly. Maintain any centralised topping-up systems in good working order and service regularly. Maintain any centralised topping-up systems in good working order and service regularly.
  
Risk of electric shocks and short circuits; for safety's sake, before performing any maintenance or repairing on the Risk of electric shocks and short circuits; for safety's sake, before performing any maintenance or repairing on the Risk of electric shocks and short circuits; for safety's sake, before performing any maintenance or repairing on the
batteries (or on the machine), remove the +/- terminals from the battery poles. batteries (or on the machine), remove the +/- terminals from the battery poles. batteries (or on the machine), remove the +/- terminals from the battery poles.
  
Risk of explosions during charging; this can occur when recharging with an unsuitable battery charger (depending on Risk of explosions during charging; this can occur when recharging with an unsuitable battery charger (depending on Risk of explosions during charging; this can occur when recharging with an unsuitable battery charger (depending on
battery Amperes) battery Amperes) battery Amperes)
  
During battery recharging operations, or whenever the battery charger plug is inserted, the machine must never be During battery recharging operations, or whenever the battery charger plug is inserted, the machine must never be During battery recharging operations, or whenever the battery charger plug is inserted, the machine must never be
switched on or moved (even manually). switched on or moved (even manually). switched on or moved (even manually).
8 8 8 CHECKS PRIOR TO STARTING UP CHECKS PRIOR TO STARTING UP CHECKS PRIOR TO STARTING UP
1. 1. 1. Check the level of the battery solution and if necessary top up with distilled water. Check the level of the battery solution and if necessary top up with distilled water. Check the level of the battery solution and if necessary top up with distilled water.
2. 2. 2. Make sure the connector Part. 1 Fig. 13 is well inserted in the socket Part. 2 Fig. 13. Make sure the connector Part. 1 Fig. 13 is well inserted in the socket Part. 2 Fig. 13. Make sure the connector Part. 1 Fig. 13 is well inserted in the socket Part. 2 Fig. 13.
Read carefully the Engine User Manual attached to this machine booklet and follow some simple instructions: Read carefully the Engine User Manual attached to this machine booklet and follow some simple instructions: Read carefully the Engine User Manual attached to this machine booklet and follow some simple instructions:
1. Check the level of oil in the engine and top up, if low, wearing protection gloves ( possibly nitrile gloves with cotton 1. Check the level of oil in the engine and top up, if low, wearing protection gloves ( possibly nitrile gloves with cotton 1. Check the level of oil in the engine and top up, if low, wearing protection gloves ( possibly nitrile gloves with cotton
inside) the oil sump (from 5,5 hp-3,75 kw) contains about 5hg of oil. The recommended oil for temperate climate is inside) the oil sump (from 5,5 hp-3,75 kw) contains about 5hg of oil. The recommended oil for temperate climate is inside) the oil sump (from 5,5 hp-3,75 kw) contains about 5hg of oil. The recommended oil for temperate climate is
10w-30.To protect engine a particular device stops the engine by switching on if oil is absent or not enough; it is 10w-30.To protect engine a particular device stops the engine by switching on if oil is absent or not enough; it is 10w-30.To protect engine a particular device stops the engine by switching on if oil is absent or not enough; it is
therefore necessary checking the oil level very often. therefore necessary checking the oil level very often. therefore necessary checking the oil level very often.
2. Refuel with switched off and cold engine only; Unlead petrol is strongly advised. Fuel tank must be fit for the purpose 2. Refuel with switched off and cold engine only; Unlead petrol is strongly advised. Fuel tank must be fit for the purpose 2. Refuel with switched off and cold engine only; Unlead petrol is strongly advised. Fuel tank must be fit for the purpose
and well cleaned. This will grant you a good and long lasting of the petrol engine filter. Please use a tank suitable to and well cleaned. This will grant you a good and long lasting of the petrol engine filter. Please use a tank suitable to and well cleaned. This will grant you a good and long lasting of the petrol engine filter. Please use a tank suitable to
use up fuel in max 2/3 months in order to have fresh fuel all the time. use up fuel in max 2/3 months in order to have fresh fuel all the time. use up fuel in max 2/3 months in order to have fresh fuel all the time.
ATTENTION: ATTENTION: ATTENTION:
KEEP FUEL OUT OF CHILDREN'S REACH , IN A DRY AND AIRY PLACE, FAR FROM HEAT SOURCES KEEP FUEL OUT OF CHILDREN'S REACH , IN A DRY AND AIRY PLACE, FAR FROM HEAT SOURCES KEEP FUEL OUT OF CHILDREN'S REACH , IN A DRY AND AIRY PLACE, FAR FROM HEAT SOURCES
E115 E115 E115
S115 S115 S115
TSM - Technological Systems by Moro Srl TSM - Technological Systems by Moro Srl TSM - Technological Systems by Moro Srl
Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy Via F.lli Zambon,9 - 33080 Fiume Veneto (PN) – Italy
Tel. +39.0434.564167 - Fax +39.0434.954069 Tel. +39.0434.564167 - Fax +39.0434.954069 Tel. +39.0434.564167 - Fax +39.0434.954069
www.tsmitaly.com – sales@tsmitaly.com www.tsmitaly.com – sales@tsmitaly.com www.tsmitaly.com – sales@tsmitaly.com
32 32 32
DURASWEEP 115 DURASWEEP 115 DURASWEEP 115
OPERATING MANUAL OPERATING MANUAL OPERATING MANUAL
V01 V01 V01