Standard Features - TSM DURASWEEP 115 Mode D'emploi

Table des Matières

Les langues disponibles

5.11

Forward and reverse pedal: Only for internal combustion engine

Part. 3 Fig. 10. This pedal has two functions depending on the position. By pressing the right side (with arrow pointing

UP) the machine goes forward while by pressing the left side (with arrow pointing DOWN) the machine withdraws. For

safety reasons, the reverse speed of the machine is very low.

5.12

Side brush engagement lever: For both models

The engagement lever Part. 1 Fig. 10 makes it possible to lower the brush from the driving seat. Remember that the side

brush must only be used for cleaning edges, profiles and corners and that it continues to rotate when the machine motor

is rotating. To lower and then activate the side brush push forward lever Part. 1 fig. 10; to disconnect the side brush

bring back the lever in the initial position by pulling it back.

ATTENTION: NEVER TOUCH THE SIDE BRUSH WITH YOUR HANDS AND NEVER PICK UP

THREADED MATERIALS.

5.13

Suction off knob: For both models

Fitted to both models Part. 1 Fig. 6. When this knob is pulled outwards, suction is disengaged. Disengage the suction

every time the filters need shaking or when passing over damp areas (with the motor on).

5.14

Centre brush engagement lever: For both models

This lever Part. 2 Fig. 6 makes it possible to engage and disengage the centre brush. By sliding the lever down along

the slot, the work position is lowered, while when the lever is slid upwards and inserted in the notch, the centre brush is

disengaged.

Gear switch

Electric switchboard check led

Filter Buzzer Button

Acoustic Indicator Button

Brushes motor switch

Ignition key

Working light switch (optional)

Charge indicator

Hour counter

GEAR SWITCH :

Part. 1 The purpose of the gear switch lever is to move the machine forward or

reverse. When the switch is in forward position (arrow pointing up) by pressing the

pedal Part. 3 Fig. 10 the machine moves forward. When the switch lever is in

reverse position (arrow pointing down) by pressing the pedal the machine moves

reverse. For safety reasons, the reverse speed is very low. If the switch is left in

central position, the machine moves neither forward nor in reverse.

ELECTRIC SWITCHBOARD CHECK LED:

Part. 2 This red led must be always switched on during functioning. If this led

should flash at regular intervals there could be technical problems within the

machine. In this case you are adviced to immediately contact assistance to check

the motorsweeper.

FILTER BUZZER BUTTON:

Part. 3 This buzzer cleans the suction filters through a motor-vibrator Part. 2 Fig. 5;

it must be pressed at least 6 / 7 times for 8 / 10 seconds each (operation to be

performed before starting work, before emptying the bin and with the motor off); to

perform this operation with motor running, close the suction by pulling the knob

Part. 1 Fig. 6.