Stryker 6254 Mode D'emploi page 40

English
UPPER CONTROL HANDLE CABLE REPLACEMENT
Tools Required:
• 5/8" Wrench
Procedure:
1 . Pull the cable and raise the extendable upper control
handle to the fully extended position .
2 . Using a 5/8" wrench, remove one side of the cable .
3 . Place the washer on the end of the new cable .
4 . Using a 5/8" wrench, attach one side of the new cable
to the chair frame in the hole where the old cable was
removed .
5 . Repeat steps 2-4 for the other end of the cable .
Figure 51 - Place the washer on the new cable
Return To Table of Contents
1-38
Service Information
6254-009-005 REV B
Figure 49 - Raise the extendable handle
Figure 50 - Remove one side of the cable
Figure 52 - Attach one side of the new cable
www.stryker.com