Stryker 6254 Mode D'emploi page 29

INSTALLING THE OPTIONAL COVER
Note: It is easiest to install the cover when the chair is hanging .
To install the optional vinyl cover:
1 . Slip the bottom pocket over the wheels .
2 . Wrap the side flaps around the chair frame .
3 . Pull the top flat down between the bars of the upper control handle and over the head support strap .
4 . Attach the Velcro ® strips .
5 . Attach the red handle strip to the Velcro
REMOVING THE OPTIONAL COVER
To remove the optional vinyl cover:
1 . Pull the red handle strip .
2 . Allow the cover to drop off the chair .
Figure 39: Slip the bottom pocket over the wheels
www.stryker.com
Operation Guide
® on the front of the cover .
Figure 40: Cover fully installed on the chair
6254-009-005 REV B
Return To Table of Contents
1-27
English