Stryker 6254 Mode D'emploi page 12

English
These instructions are printed on the backrest of the Evacuation Chair .
To use the evacuation chair:
1 . Stand behind the chair and pull the backrest and extension handle apart to unfold the chair .
WARNING
An unlocked chair can fold during use, causing injury to the passenger or operator . Always make sure the chair is locked
in the unfolded position before use .
2 . Pull the red release cable with one hand and pull up on the control handle with the other hand to extend the upper
control handle .
3 . Squeeze the red track release bar against the black cross tube . Relax your grip on the release bar and forcefully
pull the Stair-TREAD™ system to the fully extended position until both sides lock securely . Always verify both sides
of the Stair-TREAD system are locked by trying to fold it back up .
CAUTION
Release the red track release bar before clicking the Stair-TREAD system into the locked position . Failure to follow this
procedure could result in the track failing to lock . Always verify the Stair-TREAD system is locked by trying to fold it
before descending stairs .
4 . Tilt the chair back just far enough to allow the Stair-TREAD system to contact the floor .
5 . Maintaining the angle, guide the Evacuation Chair over the edge of the stairs, allowing the Stair-TREAD system to
engage the first step .
6 . Glide down the stairs until the treads are level across the edges of two or three steps .
Return To Table of Contents
1-10
Instructions
6254-009-005 REV B www.stryker.com