Top View - Stryker 6254 Mode D'emploi

USING THE HEAD SUPPORT
Upper Control Handle
WARNING
The Stryker Evacuation Chair is not recommended for use with suspected cervical, spinal, or fracture injuries .
Before using the head support, the upper control handle must be extended . First, pull the red upper control handle
release cable with one hand . Then, pull up on the handle with the other hand . Release the cable and verify the handle
is securely locked into one of the two available positions .
To attach the head support to the extendable upper control handle:
1 . Wrap the loose ends of the strap around the vertical portions of the handle, then feed them through the plastic
loops .
2 . Pull tight, and secure the strap to itself .
3 . Adjust the height by loosening the strap, moving it to the desired location, and tightening it again .
To support the passenger's head, position at the base of the head . For unconscious, or semiconscious passengers,
secure the head using the other two parts of the strap . Wrap around the passenger's head, and overlap the straps to
the desired tightness to secure . When not in use, these straps can be wrapped back around the handle and attached
to the back of the support .
www.stryker.com
Operation Guide
TOP VIEW
Slide Ring
Figures 32 - 34 - Attaching and using the head support
6254-009-005 REV B
Head Support
Return To Table of Contents
English
1-23