Stryker 6254 Mode D'emploi page 20

English
TRANSPORTING THE PASSENGER ON FLAT SURFACES
WARNING
To avoid the risk of patient injury or equipment damage, do not allow the patient to stand on the footrest .
To roll the Stryker Evacuation Chair over flat surfaces, push and guide the chair from the rear of the passenger, using
either the head end handles or the backrest tube . Lift the chair over and around obstructions with the head end and
foot end lift handles .
In addition to the head end lift handles, the extendable upper control handle can be used in any position to roll and
guide the chair . Extend the upper control handle by pulling the red release cable with one hand, and pulling up on the
control handle with the other . Release the cable to lock the handle in either the intermediate or fully extended position .
Lift the chair over and around obstructions with the head end and foot end lift handles .
CAUTION
Casters are not suitable for all surfaces . Caution should be used at all times .
Return To Table of Contents
1-18
Operation Guide
Figure 18 - Transporting the Passenger
6254-009-005 REV B www.stryker.com