Stryker 6254 Mode D'emploi page 18

English
USING RESTRAINT STRAPS - CONTINUED
To attach the ankle strap:
1 . Remove the three plastic pieces from the
strap .
2 . Thread the strap through one of the
plastic "D" rings and slide the ring down to
the end of the strap up to the white label .
3 . Loop the strap around the front leg of
the chair and pull the loose end of the
strap through the ring .
ring rests against the foot rest tube .
4 . Thread the strap through the other "D"
ring .
5 . Loop the strap around the other front leg
of the chair and pull the loose end of
the strap through the loop . Pull until the
"D" ring rests against the foot rest tube .
6 . Attach the final "male" end clip on the
strap .
Return To Table of Contents
1-16
Operation Guide
Pull until the
6254-009-005 REV B
Figure 9-17 - Attaching the leg strap
www.stryker.com