Pairing A Remote To Two Talons; Clearing Paired Remotes Or Devices From The Talon - MINN KOTA TALON Mode D'emploi

PAIRING A REMOTE TO TWO TALONS

PAIRING A REMOTE TO TWO TALONS
In order to Pair a remote to the Talon, please be sure to first Pair the Talons together. When two Bluetooth Talons are paired together,
all remotes that were paired to an individual Talon will operate both Talons. Please see the "Pairing Two Talons and Programming the
Mounting Location" section of this manual. If the two Talons are already paired together, a remote can be paired to either Talon. When
the pairing process is complete, the remote will be able to control both Talons.
1
a. Retract the anchor on both Talons by pressing the Up
button.
b. Once both Talons are fully retracted, press and hold
the Up button and the Down
Remote at the same time until the Talon Selection
LEDs on the Remote begin to scroll. After 2 seconds,
release the buttons.
c. Immediately press and hold the Up
the Down
Panel of one Talon. The Depth Indication LEDs will
begin to flash blue on both Talons. Once the LEDs
are flashing release the buttons on the Indicator
Panel. The Talon and Remote will go into Pairing
Mode for 20 seconds.
d. If a tone with three fast beeps occurs, the Talon
and Remote have successfully paired. If 20
seconds pass while in Pairing Mode and they do not
successfully pair, an error tone will sound signaling
that the Pairing has timed out.
e. If the Pair is unsuccessful, repeat the process.

CLEARING PAIRED REMOTES OR DEVICES FROM THE TALON

The Talon was designed so that all paired devices can be cleared from memory.
1
a. Retract the anchor on the Talon by pressing the Up
button.
b. Turn the power to the Talon "off".
42 | minnkotamotors.com
button on the
button and
button simultaneously on the Indicator
1a
Up Button
Down Button
1c
Talon Remote
1a
Up Button
Down Button
Indicator
Panel
Talon Selection LEDs
Talon Selection
Button
Auto Up/Down
Buttons & Pairing
Button
Indicator
Panel
©2017 Johnson Outdoors Marine Electronics, Inc.